F50 is the most versatile product of all plastiforms. Thanks to its technical characteristics, it is able to solve most of the industry’s dimensional control problems. Its fluidity and flexibility allow the F50 to easily infiltrate into and out of rooms. In short, it is possible to cut it with the Double Blade Cutter, which makes it very easy to use.
The final impression of the F50 is Semi-Soft (hardness 50 Shore A), and does not have a high deformation capacity. It accepts a maximum Extraction Constraint of 10%, and must therefore be used in forms that are not very complex to unmould.

The F50 is therefore recommended for taking impressions in simple or less complex internal shapes. It is used for both total and partial impressions.

It is also very effective in creating custom-made protections, caps, and savings against surface treatments.

The impression is very precise, and all surface details (shape, dimension, appearance, surface condition, etc.) are reproduced in µm.

f50 temp chart

f50 ca-f50-2 ca-f50-8 ca-f50-16 BAD B.A.D

Product Initial consistency Final consistency Final hardness Maximum extraction constraint Working time at 20°c Setting time at 20°c Accuracy Double Blade Cutter Caliber
F50 Fluid Flexible 50 10% +/- +/- 8 min +/- µm Yes No


The F50 is one of the best product to realize :

It can also be used for:

  • Protection and masking of parts

These applications can be easily performed by following the recommendations in the instructions provided with the product. We recommend that the F50 be poured slowly and with a nozzle and that the product flow into every corner of the target area to avoid air bubbles.

This information also applies to all other fluid products in the Plastiform range.

Impression Measurement

The F50 impression being flexible, it is controlled without contact using visual measuring systems:

  • Profile projector,
  • Microscope,
  • Optical measuring system.

It can also be checked with a contact measuring system for flexible materials in some cases (caliper with constant measuring pressure) but we always recommend using a visual inspection system.

The use of the Double Blade Cutter is recommended.

an F50 internal imprint
F50 sliced by the double blade cutter
empreinte de F50 Plastiform
Plastiform Online Video

Click to watch the video

Packaging :

Each product is delivered in 50mL cartridges, with standard injectors and nozzles.

References :

CA-F50-2 : 2 cartridges 50ml + 12 standard nozzles + 6 tips

CA-F50-8 : 8 cartridges 50ml + 48 standard nozzles + 6 tips

CA-F50-16 : 16 cartridges 50ml + 48 standard nozzles + 6 tips

Start your trial now

With the Plastiform Case, you will get every accessories required for creating 3D impressions and exploit them. Customise your case or opt for our already referenced solutions available on the website of our official distributors.

Plastiform Case
< Go Back
Go to Top