Something went wrong
Troubleshooting
Symptoms, causes and fixes.
6 articlesTroubleshooting ChartWhen an impression shows a defect, use the chart to find the cause, apply…The Impression Stays Sticky or Does Not PolymerizeAn impression that stays sticky did not polymerize completely. Something blocked the reaction, or…The Impression Is Stuck or Tore on ExtractionAn impression tears or stays stuck when the removal constraint is higher than…Bubbles or Voids in the ImpressionBubbles are air trapped during the injection. Either the tip came out of the…Dimensions Vary Between ImpressionsPlastiform has no dimensional shrinkage, so inconsistent dimensions come from the conditions. They depend…Polymerization Is Too Fast or Too SlowTemperature is almost always the cause. We give the times on the label and…
Can't find the answer?For atypical cases, contact the Rivelec technical team directly.
Contact supportGet a trainingComing soon