P35 has an initial paste-like consistency (not flowing). In this way it can be applied on vertical or overhanging surfaces. It is a non-flowing product, so it is very suitable for partial impressions. The final impression being Flexible (hardness 35 Shore A), it can deform during demoulding. The replica accepts an Extraction Constraint of up to 20%.

P35 is a product used to make partial replicas or to control external spaces not accessible for a fluid product. The impression is very accurate, and all surface details are reproduced in µm. The P35 is a product very suitable for carrying out checks on large external threads or complex shapes outside the reach of the F50 or F20.

Finally, it is a product compatible with the Double Blade Cutter. This will allow you to measure the impressions without difficulty by cutting a profile in 2 dimensions.

p35 curing time chart

p35 ca-p35-2 ca-p35-8 ca-p35-16 SOFT S.O.F.T

Product Initial consistency Final consistency Final hardness Maximum extraction constraint Working time at 20°c Setting time at 20°c Accuracy Double Blade Cutter Caliber
P35 Pasty Flexible 35 20% +/- 1 min 30 sec +/- 8 min +/- µm Yes No


The P35 is suitable for the following applications:

It can also be used for:

It is not necessary to perform complex manipulations to perform impressions in P35. However, we recommend that you apply it slowly without using a nozzle. It is also important to ensure that the product is in perfect contact with the surfaces of the target area in order to avoid air bubbles. This information also applies to all other pasty products in the Plastiform range.

Also remember to degrease the surface before any application, otherwise impurities could affect your results.

Impression Measurement

As the P35 impression is flexible, it is controlled without contact using visual measuring systems:

  • Profile projector,
  • Microscope,
  • Optical measuring system.

This product is particularly compatible with the Double Blade Cutter. We recommend using it to optimize your results.

Contrôle P35 Plastiform
Contrôle pièce P35 Plastiform
P35 Plastiform Double Blade Cutter
Plastiform Online Video

Click to watch the video

Packaging :

Each product is delivered in 50mL cartridges, with standard injectors and nozzles.

References :

CA-P35-2 : 2 cartridges 50ml + 12 standard nozzles + 6 tips

CA-P35-8 : 8 cartridges 50ml + 48 standard nozzles + 6 tips

CA-P35-16 : 16 cartridges 50ml + 48 standard nozzles + 6 tips

Start your trial now

With the Plastiform Case, you will get every accessories required for creating 3D impressions and exploit them. Customise your case or opt for our already referenced solutions available on the website of our official distributors.

Plastiform Case
< Go Back
Go to Top